TRB245

Product Catalog
Share:

FEATURES

MOBILE

 Mobile module 4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps
 SIM switch 2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection
 Status Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID
 SMS SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP
 USSD Supports sending and reading Unstructured Supplementary Service Data messages
 Black/White list Operator black/white list
 Multiple PDN Possibility to use different PDNs for multiple network access and services
 Band management Band lock, Used band status display
 APN Auto APN
 Bridge Direct connection (bridge) between mobile ISP and device on LAN
 Passthrough Router assigns its mobile WAN IP address to another device on LAN

 ETHERNET

 LAN 1 x LAN port, 10/100 Mbps, compliance with IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX

 NETWORK

 Routing Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, NHRP)
 Network protocols TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SMNP, MQTT, Wake On Lan (WOL)
 VoIP passthrough   support H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
 Connection monitoring Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection
 Firewall Port forward, traffic rules, custom rules
 DHCP Static and dynamic IP allocation, DHCP Relay, Relayd
 QoS / Smart Queue   Management (SQM) Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
 DDNS Supported >25 service providers, others can be configured manually
 Network backup Mobile, VRRP, Wired options, each of which can be used as an automatic Failover
 Load balancing Balance Internet traffic over multiple WAN connections
 SSHFS Possibility to mount remote file system via SSH protocol

 SECURITY

 Authentication Pre-shared key, digital certificates, X.509 certificates, TACACS+, Radius, IP & Login attempts block
 Firewall Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
 Attack prevention DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
 VLAN Port and tag based VLAN separation
 Mobile quota control Custom data limits for both SIM cards
 WEB filter Blacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
 Access control Flexible access control of TCP, UDP, ICMP packets, MAC address filter

 VPN

 OpenVPN Multiple clients and a server can run simultaneously, 27 encryption methods
 OpenVPN Encryption

DES-CBC 64, RC2-CBC 128, DES-EDE-CBC 128, DES-EDE3-CBC 192, DESX-CBC 192,

BF-CBC 128, RC2-40-CBC 40, CAST5-CBC 128, RC2-64-CBC 64, AES-128-CBC 128, AES-128-CFB 128, AES-128-CFB1 128, AES-128-CFB8 128, AES-128-OFB 128, AES-128-GCM 128, AES-192-CFB 192, AES-192-CFB1 192, AES-192-CFB8 192, AES-192-OFB 192, AES-192-CBC 192, AES-192-GCM 192, AES-256-GCM 256, AES-256-CFB 256, AES-256-CFB1 256, AES-256-CFB8 256, AES-256-OFB 256, AES-256-CBC 256

 IPsec IKEv1, IKEv2, with 14 encryption methods for IPsec (3DES, DES, AES128, AES192, AES256, AES128GCM8, AES192GCM8, AES256GCM8, AES128GCM12, AES192GCM12, AES256GCM12, AES128GCM16, AES192GCM16, AES256GCM16)
 GRE GRE tunnel, GRE tunnel over IPsec support
 PPTP, L2TP Client/Server instances can run simultaneously, L2TPv3, L2TP over IPsec support
 Stunnel Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
 DMVPN Method of building scalable IPsec VPNs
 SSTP SSTP client instance support
 ZeroTier ZeroTier VPN client support
 WireGuard WireGuard VPN client and server support
 Tinc Tinc offers encryption, authentication and compression in it's tunnels. Client and server support.

 MODBUS TCP SLAVE

 ID range Respond to one ID in range [1;255] or any
 Allow Remote Access Allow access through WAN
 Custom registers MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionalityMODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionality

 MODBUS TCP MASTER

 Supported functions 01, 02, 03, 04, 05, 06, 15, 16
 Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC)

 MODBUS RTU MASTER (RS232)

 Supported baud rates From 300 to 115200
 Supported functions 01, 02, 03, 04, 05, 06, 15, 16
 Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
 Number of data bits From 7 to 8
 Number of stop bits 1 or 2
 Parity None, Even, Odd
 Flow None, RTS/CTS, Xon/Xoff
 Duplex Full duplex

 MODBUS RTU MASTER (RS485)

 Supported baud rates From 300 to 300000
 Supported functions 01, 02, 03, 04, 05, 06, 15, 16
 Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
 Number of data bits 7 or 8
 Number of stop bits 1 or 2
 Parity None, Even, Odd
 Flow None, Xon/Xoff
 Duplex Half duplex

 MODBUS DATA TO SERVER

 Protocol HTTP(S), MQTT, Azure MQTT

 MQTT GATEWAY

 MQTT Gateway Allows sending commands and receiving data from MODBUS Master through MQTT broker

 DNP3

 Supported modes TCP Master, DNP3 Outstation, RTU Master

 MONITORING & MANAGEMENT

 WEB UI HTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log
 FOTA Firmware update from server, automatic notification
 SSH SSH (v1, v2)
 SMS SMS status, SMS configuration, send/read SMS via HTTP POST/GET
 Call Reboot, Status, Mobile data on/off, Output on/off, answer/hang-up with a timer
 TR-069 OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem
 MQTT MQTT Broker, MQTT publisher
 SNMP SNMP (v1, v2, v3), SNMP Trap
 JSON-RPC Management API over HTTP/HTTPS
 MODBUS MODBUS TCP status/control
 RMS Teltonika Remote Management System (RMS)

 IOT PLATFORMS

 Cloud of Things Allows monitoring of: Device data, Mobile data, Network info, Availability
 ThingWorx Allows monitoring of: WAN Type, WAN IP, Mobile Operator Name, Mobile Signal Strength, Mobile Network Type
 Cumulocity Allows monitoring of: Device Model, Revision and Serial Number, WAN Type and IP, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength
 Azure IoT Hub Can send device IP, Number of bytes send/received, Temperature, PIN count to Azure IoT Hub server, Mobile connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, SIM State, PIN state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type

 SYSTEM CHARACTERISTICS

 CPU Qualcomm QCA9531, MIPS 24kc, 650 MHz
 RAM 64 MB, DDR2
 FLASH storage 16 MB, SPI Flash

 FIRMWARE / CONFIGURATION

 WEB UI Update FW from file, check FW on server, configuration profiles, configuration backup
 FOTA Update FW
 RMS Update FW/configuration for multiple devices at once
 Keep settings Update FW without losing current configuration

 FIRMWARE CUSTOMIZATION

 Operating system RutOS (OpenWrt based Linux OS)
 Supported languages Busybox shell, Lua, C, C++
 Development tools SDK package with build environment provided

 LOCATION TRACKING

 GNSS GPS, GLONASS, BeiDou, Galileo and QZSS
 Coordinates GNSS coordinates via WebUI, SMS, TAVL, RMS
 NMEA NMEA 0183
 NTRIP NTRIP protocol (Networked Transport of RTCM via Internet Protocol)
 Server software Supported server software TAVL, RMS
 Geofencing Configurable multiple geofence zones

 SERIAL

 RS232 Terminal block connector: TX, RX, RTS, CTS
 RS485 Terminal block connector: D+, D-, R+, R- (2 or 4 wire interface)
 Serial functions Console, Serial over IP, Modem, MODBUS gateway, NTRIP Client

 INPUT / OUTPUT

 Input 3 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high. 1 x Analog input (0 - 30 V)
 Output 3 x Digital Output, Open collector output, max output 30 V, 300 mA
 Events Email, RMS, SMS
 I/O juggler Allows to set certain I/O conditions to initiate event

 POWER

 Connector 2 pins in 16-pin industrial terminal block
 Input voltage range 9 – 30 VDC, reverse polarity protection, surge protection +/-1 kV 50 µs max
 Power consumption Idle: < 1.2 W, Max: < 5 W

 PHYSICAL INTERFACES

 Ethernet 1 x RJ45 port, 10/100 Mbps
 I/O’s 3 x Configurable I/O, 1 x Analog input in 16 pin terminal block
 Status LEDs 3 x connection status LEDs, 3 x connection strength LEDs, 1 x power LED, 1 x Eth port status LED
 SIM 2 x SIM slots (Mini SIM – 2FF), 1.8 V/3 V, double stacked SIM tray
 Power 1 x 16-pin terminal block
 Antennas 1 x SMA connector for LTE, 1 x SMA connector for GNSS
 RS232 4 pins in 16-pin terminal block (TX, RX, RTS, CTS)
 RS485 4 pins in 16-pin terminal block (D+, D-, R+, R-)
 Reset Reboot/User default reset/Factory reset button

 PHYSICAL SPECIFICATION

 Casing material Aluminum housing
 Dimensions (W x H x D) 110 x 50 x 100 mm
 Weight 165 g
 Mounting options DIN rail (can be mounted on two sides), flat surface placement

 OPERATING ENVIRONMENT

 Operating temperature -40 °C to 75 °C
 Operating humidity 10% to 90% non-condensing
 Ingress Protection Rating IP30

Related articles

Product Catalog

TSW200

Post Cover
Product Catalog

TRB141

Post Cover
Product Catalog

RUT200

Post Cover
Product Catalog

RUTX50

Post Cover